Next: Uvflag: Flagging Selected Antennas
Up: FLAGGING DATA
Previous: FLAGGING DATA
The Miriad task uvflag
is used to change flags corresponding
to the visibility data. Using the keywords select, line
and edge, one can
select a part of the uv-data that have been identified with problems.
For all selected correlations, the flags are then set to the value
specified with the keyword flagval. An example is provided below of
flagging the bad correlations shown in the data inspection process:
uvflag% inp
Task: uvflag
vis = gc_rx1.lsb.tsys
select = window(1,2,3,4),ant(5)(8)
line =
edge =
flagval = flag
options =
log =
The setup above is to flag the four spectral chunks (s1-4)
on the baseline 5-8.
Jun-Hui Zhao (miriad for SMA)
2012-07-09